CNC Plate Cutting and Drilling Machine

Driving Model: pneumatic drive System.

Application: Used to select the die position for punching operations of the corresponding die position.

Three die positions correspond to three punches, and each die position is equipped with a cylinder. A cushion block is connected to the cylinder piston rod, and the cushion block is installed between the punch rod and the cylinder pressure head. According to computer instructions, the punch is automatically selected, that is, the corresponding cylinder is selected to push the corresponding cushion.

1. Machine Model and Configuration

2.1 Mechanical Part

No.	Item	YBJ100	YBJZ100	YBJ120D	YBJ120
1	Machine Layout Area	5*3.5 M			5*4.5 M
2	No. of Hosts	1 set
3	No. of Workbench Bases	1 set
4	No. of Y-Slide	1 set
5	No. of X-direction Slide	1 set
6	No. of Clamps	2 sets
7	No. of drilling spindle heads	NO	1 set	NO
8	Pneumatic control system	1 set
9	Hydraulic control system	1 set
10	Buyer Preparation Working	Installation Site-cement foundation, embedded slabs and anchor bolts required by equipment, make the foundation according to the foundation plan provided by the supplier

2.2 Electric control Part

1	CNC Controller system	PLC control system
2	Drive System	Panasonic Servo Motor

3. The main technical parameters of the machine

No.	Item	YBJ100	YBJZ100	YBJ120D	YBJ120
1	Processing plate size	1500*800mm			1500*1500mm
2	Processing plate thickness	5-25mm
3	Punching force	1000KN		1200KN
4	Maximum punching (drilling) hole diameter	Φ26mm	Φ26mm Drilling OD Φ50	Φ26mm	Φ30mm-25mm Φ40mm-20mm
5	Total number of modules	3 Pcs	4 Pcs	3 Pcs
6	Number of punching die	2 Pcs			3 Pcs
7	Number of print header groups	1 Group			NO
8	Prefix	10 Pcs			NO
9	Header size	(L*W*H)14*10*19mm			NO
10	Number of CNC axes	2
11	X, Y axis servo motor power	2*2KW
12	X, Y axis feeding speed	20m/min
13	Punching speed	50-55 Times/Min
14	Total weight of equipment	6T	6.5T	7.8T	9.5T

4. Machine working environment

1	Power supply	3 Phase 4-Wire System
2	Voltage	3 Phase 380V±10%
3	Frequency	50Hz
4	Operating Temperature	0℃-40℃
5	Relative Humidity	<90% no condensation
6	Compressed Air	Pressure: 0.8MPa Flow rate: 0.1m³/min

4. Machine parts introduction

The equipment is mainly composed of Punching Host Unit, Workbench Moving Unit, Clamp Assembly, Pneumatic System, Electrical System, Hydraulic System, etc.