English
Русский
Español
العربية
Steel Plate Punching Shear
The distance from the upper point of the drilling spindle (without a drill in the spindle) up to the table surface is 180mm, we designed this distance can satisfy the Max. drill dimater 50mm. And the drill spindle adopts hydraulic feeding, can control the stroke itself, when the drill head touch the workpieces, it will turn to feeding (you just need to adjust the feeding speed), don't need measure the length of drill manually.
There are one service position of marking and two positions of punching on the machine. While in marking, put the required characters into the character box and fill the vacancy with blank characters, then screw the bolts to tight, insert the character box to the fixed groove at the top of the piston rod. The punching mould shall be selected in accordance with the aperture and plate thickness. The punch is fixed on the rod to tighten the screw, and put the hollowing block into the base of cavity die.
1. Brief Introduction:
The YBJ200 CNC Hydraulic Connecting Plate Punching Machine is often used in the production of Iron/Steel Towers in the Power transmission and transformation industry and the production of metal structural parts in the construction and bridge industries. It is mainly used for punching, drilling and typing of connecting plates.
2. Machine Model and Configuration:
2.1 Mechanical Part
| No. | Item | YBJ200 |
| 1 | Machine Layout Area | 5*3.5 M |
| 2 | No. of Hosts | 1 Set |
| 3 | No. of Workbench Bases | 1 Set |
| 4 | No. of Y-Slide | 1 Set |
| 5 | No. of X-direction Slide | 1 Set |
| 6 | No. of Clamps | 2 Sets |
| 8 | Pneumatic control system | 1 Set |
| 9 | Hydraulic control system | 1 Set |
| 10 | Buyer Preparation Working | Installation Site-cement foundation, embedded slabs and anchor bolts required by equipment, make the foundation according to the foundation plan provided by the supplier |
2.2 Electric control Part
| 1 | CNC Controller system | PLC control system |
| 2 | Drive System | Panasonic Servo Motor |
3. The main technical parameters of the machine
| No. | Item | YBJ200 |
| 1 | Processing plate size | 2000*500mm |
| 2 | Processing plate thickness | 5-25mm |
| 3 | Punching force | 1000KN |
| 4 | Maximum punching diameter | Φ26mm |
| 5 | Total number of modules | 3 Pcs |
| 6 | Number of punching die | 2 Pcs |
| 7 | Number of CNC axes | 2 |
| 8 | X, Y axis servo motor power | 2*2KW |
| 9 | X, Y axis feeding speed | 20m/min |
| 10 | Punching speed | 50-55 Times/Min |
| 11 | Total weight of equipment | 6T |
4. Machine working environment
| 1 | Power supply | 3 Phase 4-Wire System |
| 2 | Voltage | 3 Phase 415V±10% |
| 3 | Frequency | 50Hz |
| 4 | Operating Temperature | 0℃-40℃ |
| 5 | Relative Humidity | <90% no condensation |
| 6 | Compressed Air | Pressure: 0.8MPa Flow rate: 0.1m³/min |
5. Machine parts introduction
The equipment is mainly composed of Punching Host Unit, Workbench Moving Unit, Clamp Assembly, Pneumatic System, Electrical System, Hydraulic System, etc.
