English
Русский
Español
العربية
Punching Stainless Steel Plate
The hydraulic pressure system is mainly composed of oil tank, punching & marking regulator, pressure system block and drill system block. Each part is connected with steel pipe or hose, and oil tanks are driven under the control of electrical CNC system to realize calibration, clamping, pressing, punching, drilling and marking etc.High pressure pump and low pressure pump is installed on the oil tank to provide hydraulic power to the whole system.
The power supply of this CNC punching machine for joint plates is AC380V, 35KVA, and distributed to a drive supply of AC415V, AC200V and a control supply of AC220V by master switch QF1, servo transformer, and control transformer. The drive supply of AC415V is for the motor of oil pump; the drive supply of AC200V is for servo motor; the control supply of AC220V is for CNC, DC24V regulated power supply, AC contactor, and magnet valves. The DC24V supply is for servo drive, CNC system, PLC and proximity switch.
1. Brief Introduction:
The YBJ200 CNC Hydraulic Connecting Plate Punching Machine is often used in the production of Iron/Steel Towers in the Power transmission and transformation industry and the production of metal structural parts in the construction and bridge industries. It is mainly used for punching, drilling and typing of connecting plates.
2. Machine Model and Configuration:
2.1 Mechanical Part
| No. | Item | YBJ200 |
| 1 | Machine Layout Area | 5*3.5 M |
| 2 | No. of Hosts | 1 Set |
| 3 | No. of Workbench Bases | 1 Set |
| 4 | No. of Y-Slide | 1 Set |
| 5 | No. of X-direction Slide | 1 Set |
| 6 | No. of Clamps | 2 Sets |
| 8 | Pneumatic control system | 1 Set |
| 9 | Hydraulic control system | 1 Set |
| 10 | Buyer Preparation Working | Installation Site-cement foundation, embedded slabs and anchor bolts required by equipment, make the foundation according to the foundation plan provided by the supplier |
2.2 Electric control Part
| 1 | CNC Controller system | PLC control system |
| 2 | Drive System | Panasonic Servo Motor |
3. The main technical parameters of the machine
| No. | Item | YBJ200 |
| 1 | Processing plate size | 2000*500mm |
| 2 | Processing plate thickness | 5-25mm |
| 3 | Punching force | 1000KN |
| 4 | Maximum punching diameter | Φ26mm |
| 5 | Total number of modules | 3 Pcs |
| 6 | Number of punching die | 2 Pcs |
| 7 | Number of CNC axes | 2 |
| 8 | X, Y axis servo motor power | 2*2KW |
| 9 | X, Y axis feeding speed | 20m/min |
| 10 | Punching speed | 50-55 Times/Min |
| 11 | Total weight of equipment | 6T |
4. Machine working environment
| 1 | Power supply | 3 Phase 4-Wire System |
| 2 | Voltage | 3 Phase 415V±10% |
| 3 | Frequency | 50Hz |
| 4 | Operating Temperature | 0℃-40℃ |
| 5 | Relative Humidity | <90% no condensation |
| 6 | Compressed Air | Pressure: 0.8MPa Flow rate: 0.1m³/min |
5. Machine parts introduction
The equipment is mainly composed of Punching Host Unit, Workbench Moving Unit, Clamp Assembly, Pneumatic System, Electrical System, Hydraulic System, etc.
