English
Русский
Español
العربية
Name Plate Punching Machine
Hydraulic metal plate punching and marking machine Driving Model: pneumatic drive System. Application: Used to select the die position for punching operations of the corresponding die position. Three die positions correspond to three punches, and each die position is equipped with a cylinder. A cushion block is connected to the cylinder piston rod, and the cushion block is installed between the punch rod and the cylinder pressure head. According to computer instructions, the punch is automatically selected, that is, the corresponding cylinder is selected to push the corresponding cushion.
1. Brief Introduction:
The YJX CNC Hydraulic Connecting Plate Punching Machine is often used in the production of Iron/Steel Towers in the Power transmission and transformation industry and the production of metal structural parts in the construction and bridge industries. It is mainly used for punching, drilling and typing of connecting plates.
2. Machine Model and Configuration
2.1 Mechanical Part
| No. | Item | YBJ100 |
| 1 | Machine Layout Area | 5*3.5 M |
| 2 | No. of Hosts | 1 Set |
| 3 | No. of Workbench Bases | 1 Set |
| 4 | No. of Y-Slide | 1 Set |
| 5 | No. of X-direction Slide | 1 Set |
| 6 | No. of Clamps | 2 Sets |
| 8 | Pneumatic control system | 1 Set |
| 9 | Hydraulic control system | 1 Set |
| 10 | Buyer Preparation Working | Installation Site-cement foundation, embedded slabs and anchor bolts required by equipment, make the foundation according to the foundation plan provided by the supplier |
2.2 Electronic Control Part
| 1 | CNC Controller system | PLC control system |
| 2 | Drive System | Panasonic Servo Motor |
3. The main technical parameters of the machine
| No. | Item | YBJ100 |
| 1 | Processing plate size | 1500*800mm |
| 2 | Processing plate thickness | 5-25mm |
| 3 | Punching force | 1000KN |
| 4 | Maximum punching diameter | Φ26mm |
| 5 | Total number of modules | 3 Pcs |
| 6 | Number of punching die | 2 Pcs |
| 7 | Number of print header groups | 1 Group |
| 8 | Prefix | 10 Pcs |
| 9 | Header size | (L*W*H)14*10*19mm |
| 10 | Number of CNC axes | 2 |
| 11 | X, Y axis servo motor power | 2*2KW |
| 12 | X, Y axis feeding speed | 20m/min |
| 13 | Punching speed | 50-55 Times/Min |
| 14 | Total weight of equipment | 6T |
4. Machine working environment
| 1 | Power supply | 3 Phase 4-Wire System |
| 2 | Voltage | 3 Phase 415V±10% |
| 3 | Frequency | 50Hz |
| 4 | Operating Temperature | 0℃-40℃ |
| 5 | Relative humidity | <90% no condensation |
| 6 | Compressed Air | Pressure: 0.8MPa Flow rate: 0.1m³/min |
Machine parts introduction
The equipment is mainly composed of Punching Host Unit, Workbench Moving Unit, Clamp Assembly, Pneumatic System, Electrical System, Hydraulic System, etc.
