CNC Marking and Punching Machine for steel Plate

The cnc marking punching and drilling machine for steel plate, there are two hydraulic clamps on the sliding plate, their location can be moved alongside the Axis X so as to adjust different work piece. While in adjustment, loose the screw and press plate, move the clamp by hand to the adequate place, fasten the screw and press plate again. In the vertical direction, the clamp is in the condition of floating. To the joint plate with slight unevenness, they may be arched during punching, and then the clamp will be moved accordingly to avoid the breakage of clamp. A original location device is installed at the left side of the sliding plate, when the hydraulic cylinder push the locating plate at an angle of 90°, the locating surface is just at the same direction to the Axis Y, and form a rectangle with two clamp surfaces (direction of Axis X) to calibrate the original place of joint plate.

The upper and lower jaws of clamp are spliced which are convenient to replace after abrasion.